HyPerformance (HPR) 260 Specifications:
• Production cutting capacity (piercing) - mild steel 32 mm (1 1/4")
• Maximum pierce capacity - mild steel 32 mm (1 1/4")
• Maximum cutting capacity (edge start) - mild steel 64 mm (2 1/2")
     
Capacity    
     Mild Steel Dross free
Production (pierce)
Severence (edge starts)		 32 mm (1-1⁄4")
32 mm (1-1⁄4")
64 mm (2-1⁄2")
     Stainless Steel Production (pierce)
Severence (edge starts)		 32 mm (1-1⁄4")
50 mm (2")
     Aluminum Production (pierce)
Severence (edge starts)		 45 mm (1-3/4")
80 mm (3.2")
Speed* (Mild Steel) Optimum quality 12 mm (1/2")
3850 mm/m
(145 ipm)
Cut Angle ISO 9013 range** 2-4
Weldability   Ready to weld
 
 Process Gasses by Material:
 (plasma/shield)
Mild Steel 02/Air, 02/02
Stainless Steel H35/N2, N2/N2, H35-N2/N2, F5/N2
Aluminum H35/N2, Air/Air,
H35-N2/N2
Process amps Not all processes available
for all materials		 30-260

* Note: Take care in comparison: competitors often show maximum cutting speeds rather than speeds that deliver the best cuts, as shown above. Cut speeds listed above deliver best cut quality, but cut speeds can be up to 50% faster.

** ISO 9013 is a standard that defines cut quality of thermally cut parts. The lower the range (range 1 is the lowest), the smaller the angle on the cut face. Cut angle in range 4 is better than in range 5.