 |
|
| HyPerformance (HPR) 400XD Specifications: |
| • Virtually dross free cutting capacity - mild steel 38 mm (1 1/2") |
| • Maximum pierce capacity - mild steel 50 mm (2") |
| • Maximum cutting capacity (edge start) - mild steel 80 mm (3.2") |
| |
|
|
| Capacity |
|
|
| Mild Steel |
Virtually dross free
Production (pierce)
Severence (edge starts) |
38 mm (1-1/2")
50 mm (2")
80 mm (3.2") |
| Stainless Steel |
Production (pierce)
Severence (edge starts) |
45 mm (1-3/4")
80 mm (3.2") |
| Aluminum |
Production (pierce)
Severence (edge starts) |
45 mm (1-3/4")
80 mm (3.2") |
| Speed* (Mild Steel) |
Optimum quality |
25 mm (1")
2159 mm/m
(85 ipm) |
| Cut Angle |
ISO 9013 range** |
2-5 |
| Weldability |
|
Ready to weld |
| |
Process Gasses by Material:
(plasma/shield) |
|
Mild Steel |
02/Air, 02/02
Ar/Air |
|
Stainless Steel |
H35/N2, N2/N2, H35-N2/N2, F5/N2
Ar/Air, Ar//N2 |
|
Aluminum |
H35/N2, Air/Air,
H35-N2/N2
Ar/Air, Ar//N2 |
| Process amps |
Not all processes available
for all materials |
30-400 |
* Note: Take care in comparison: competitors often show maximum cutting speeds rather than speeds that deliver the best cuts, as shown above. Cut speeds listed above deliver best cut quality, but cut speeds can be up to 50% faster. |
** ISO 9013 is a standard that defines cut quality of thermally cut parts. The lower the range (range 1 is the lowest), the smaller the angle on the cut face. Cut angle in range 4 is better than in range 5. |
