Arc Voltage Control
- DSP servo system is the most advanced control available
- Rapid responce means arc voltage control available for high, intermediate or low-speed arc cutting
Initial Height Positioning
- Patented plate sensinig technique requires no extermal switches or devices
- Manual positioning if automatic initial height positioning is not desired
Programmable Partial Raise
- Allows retraction distance to be set between 0' and dull raise
- improves cycle time and output
Arc Voltage Control Limiter
- Prevents torch damage during kerf crossing
Cycle Complete Signal
- Minimizes cycle time by alerting the machine controller that the plasma torch has been fully retracted.
Gas Preflow
- Starts simultaneously with initial torch height positioning
- Saves several seconds on each cut, allowing more cut pieces per hour
Retraction Delay
- Selectable delay time allows current slope-down to occur prior to retracting
torch, extending electrode life
Corner
- Allows the arc voltage control to be disabled while cutting
- Prevents the torch from driving into the workpiece during corners or when initially piercing heavy plate
|
