Max 200 Specifications:
• Production cutting capacity (piercing) - mild steel 1" (25 mm
• Maximum pierce capacity - mild steel 1" (25 mm)
• Maximum cutting capacity (edge start) - mild steel 2" (50 mm)
     
Capacity    
     Mild Steel Virtually dross free
Production (pierce)
Severence (edge starts)		 25 mm (1")
25 mm (1")
50 mm (2")
     Stainless Steel Production (pierce) Severence (edge starts) 25 mm (1")
50 mm (2")
     Aluminum Production (pierce)
Severence (edge starts)		 25 mm (1")
50 mm (2")
Speed* (Mild Steel) Optimum quality 12 mm (1/2")
2159 mm/m
(85 ipm)
Cut Angle ISO 9013 range** 4-5
Weldability   Ready to weld
 Process Gasses by Material:
 (plasma/shield)
Mild Steel Air/Air, O2/Air,
N2, CO2
Stainless Steel Air/Air, N2/Air,
N2/CO2, H35/N2
Aluminum Air/Air, N2/Air,
N2/CO2, H35/N2
Process amps Not all processes available
for all materials		 40-200
beveling (200)

* Note: Take care in comparison: competitors often show maximum cutting speeds rather than speeds that deliver the best cuts, as shown above. Cut speeds listed above deliver best cut quality, but cut speeds can be up to 50% faster.

** ISO 9013 is a standard that defines cut quality of thermally cut parts. The lower the range (range 1 is the lowest), the smaller the angle on the cut face. Cut angle in range 4 is better than in range 5.